Handlebar mount Mini-rocker switch assembly
Exact positioning may vary depending on ATV make and model.
It is recommended that the switch be installed on the left handlebar.
A piece of electrical tape around the handlebar will help prevent
rotation of mount on the handle bar. Do not tighten over any hoses or
cables. Once the handle bar switch is mounted, route the two bullet
terminal wires back to where the contactor will be mounted. Splice
the end of the red 20ga wire to key controlled electrical wire of the
ATV. Using a test light locate a suitable wire from the ATV key
switch. The wire should only have power when the key is in the "ON"
position.
Use a test light to locate a suitable wire.
1-800-345-4545 jegs.com
