5
Install Batteries
1. Remove the battery cover from the transmitter
2. Install 4 AA alkaline dry cell batteries
3. Insert the 4 AA batteries according to the polarity
4. Replace the battery cover
Receiver Binding
1. Press and hold the “binding button” on the receiver
2. While holding the binding button, turn the vehicle
power switch to On
3. The LED of the receiver will blinks indicating that it is
searching for a transmitter to bind with
4. Turn the transmitter power switch to On
5. Once the transmitter and the receiver are bound
together, the receiver’s LED light will turn solid
6. This may take up to 30 seconds, otherwise, repeat
step 1 to 5.
Fail-Safe Adjustment
1. Press and hold the receiver binding button until the
LED light flashes
2. Adjust the throttle trigger and steering wheel to adjust
the position
3. Press the binding button to program. Once the positions
have been programmed, the LED light will flash and
stay solid
Power Alarm
1. No Activity Alarm: When the steering wheel (ST),
throttle trigger (TH) or any button is not operated for
15 minutes, a slow beeping alarm will sound to indicate
that the power should be turned off.
2. Low Battery Voltage Alarm: A quick beeping alarm
sounds and the power LED light will blink.
Bind Button
