This document is protected by copyrights.
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
21. If machine falls on hard surface, from height, is wet, or has other damage that
could affect technical state of machine, stop operation and immediately
send
machine to service center for inspection.
Minibeast
drilling machine must be connected to "protected power source" which is
properly grounded. Improperly connecting the grounding wire can result in the risk of
electrical shock. Check with a qualified electrician if you are in doubt as to whether
the outlet is properly grounded. Do not modify the plug provided with the tool. Never
remove the grounding prong from the plug. Do not use tool if the cord or plug is
damaged, have it repaired before using. If the plug will not fit the outlet, have a
proper outlet installed by a qualified electrician. The Minibeast must be plugged into
an appropriate outlet, properly installed and grounded in accordance with all codes
and ordinances. If in doubt of proper grounding, call a qualified electrician.
3.
STARTUP AND OPERATION
3.1 Operating instructions (Before you begin)
Remove all contents from the packaging and inspect to ensure no damage was
incurred during shipping. Your Minibeast package should include the following;
Spoke Handles
Qty 3
Safety Chain
Qty 1
4mm Allen Key
Qty 1
3.2 Before you Cut
Before positioning the machine on work piece always make sure that:
WARNING! Read safety precautions before starting.
WARNING! Safety rules must be closely observed.
