BM-7
This document is protected by copyrights.
Copying, using, or distributing without permission of JEI GROUP LTD is prohibited.
12
3.3. Adjusting the bevel width
Unplug the machine from the power source. Next, loosen the lever (
1
, Fig. 5), rotate
the sleeve (
2
) so that the scale
3
shows the required bevel width, and then retighten
the screw.
Fig. 5.
Adjusting the bevel width
3.4. Adjusting the guide for bevelling with radius
Unplug the machine from the power source, and then in the manner described before
loosen the lever and rotate the sleeve to set the surface
1
(Fig.
6)
on the same height
as the end of the
cutting
edge
2
. You can also use an optional radius insert positioner
to set the guide properly. Next, retighten
the lever, bevel a test edge, and then readjust
the position of the guide if necessary.
Fig. 6.
Guide adjusted for bevelling with radius
1
2
3
2
1
