3.7 Alarm in case of telephone line cut or faulty
Exclusively with
enabled , if the control panel detects
the cut or failure of the telephone line, if the alarm is in away
/home status, immediately activates the siren.If the alarm is
disarmed the control panel give the warning regarding the
telephone line failure, Beep for 60 seconds,Beep for 60
seconds, if within this time period the telephone line back to
normal or disarm command is typed, the notice ceases, or after
the 60 seconds the siren will be activated (only if the function is
enable. When the telephone line is back to normal, The display
shows the following information:
function
Direct commands
(available on DISARM Status only)
Disable telephone line trouble control----------------------- 747410#
Enable telephone line trouble control ----------------------- 747411#
Disable Siren during telephone line trouble event-------- -858512#
Enable siren during telephoneline trouble event ---------- 858513 #
3.8 Anti- tamper alarm function
3.8.1
When the control panel receives the tamper signal , the
control panel immediately activates the siren and the dialer to
call the Supervisory institute CMS and stored telephone
numbers. After resetting the sensor that has been attempting to
tamper, the same sensor will be 'ready for reporting other
tamper alarm.
The antitamper function is always enable, even when the
system is disarmed.
3.8.2
Tampering information on the LCD display .
The display shows the number of tampered zone
e20
3.8.3 To disable the detection of tampering to access the
settings of the motion sensors, enter the programming mode
by
pressing the * key for 3 seconds, then type the password, the
tamper is disabled until the system is in programming status
BASIC SETTING & OPERATION
