Screen track
“nub”
Installation Instructions
for Builders Vinyl Sliding Patio Door Handing Reversal (SVC001)
©2021 JELD-WEN, Inc. This publication and its contents are owned by or licensed to JELD-WEN, Inc. or its affiliates or third parties, and are protected by copyright, trademark, and other laws. Unauthorized use
or duplication is prohibited. JELD-WEN reserves the right to change product specifications without notice. Please visit our website at
jeld-wen.com
for current information.
All rights reserved.
Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
SVC001 10/21
FINISH CONVERSION
FINISH CONVERSION
2. Tap the filler into the
groove at the new
top of the frame with
a rubber mallet (this
will cover former
weep holes).
3. Reinstall screen track
with “nub” facing the
interior.
4. Position top of screen
into top channel.
5. Lift bottom up and over onto track.
6. Extend all four rollers by turning adjustment screws clockwise until
the screen is level and a slight pressure is felt.
7. The patio door is now ready for installation.
1. On the exterior, now
the bottom, look for
a groove filler (a long,
thin vinyl strip that
fits into a groove in
the frame). If a groove
filler is present, lift one
end with a flat head
screwdriver and pull
out to remove.
The information contained herein is provided solely for informational and/or educational purposes. JELD-WEN disclaims any and all liability associated with the use
and/or provision of this information. Any reliance upon the information or advice is at the risk of the party so relying. The information contained herein may be
changed from time to time without notification.