8
SETTING UP YOUR TANK
Instructional videos available online at
Jellyfishart.com
under the “Support” header.
1. Rinse your aquarium and black foam sponge pad out with fresh water.
This is to remove any potential dust that may have accumulated during
production. Rinsing can be done in a sink or by taking the aquarium into
a shower/bathtub. Be careful to avoid scratching the acrylic! The black
foam insert should be rung out several times and air dried before adding
into your aquarium. Dry your aquarium with a clean cloth.
2. Seat the LED bulb into socket of base.
3. Connect power supply to the black socket plug.
4. The air pump can be installed either outside of the aquarium, or within
the base.
5. Connect the two flexible silicone tubing ends coming out of the
aquarium bottom to the air pump.
IMPORTANT: Make sure the pump is
positioned to avoid any kinks to the flexible lines that could result in air
blockage.
6. Place aquarium on the base. Ensure the alignment notch is properly
centered with the alignment peg under the aquarium.
7. Note: Optional use airflow control valves are not typically needed and
may be reserved for optional use in the future.
Please note:
Keep aquarium away from direct sunlight, heat sources, or
electrical equipment. Place on a sturdy, level, and flat surface. Ensure that
you have two wall outlets within close proximity. It is encouraged that the
cordage has a “drip loop” under the electrical outlet, so any water that may
be spilled will not run down the cord directly into the electrical outlet.