ZR12-AL USER GUIDE
Trouble Shooting
CAUSE
CURE
SYMPT
OM
The
mains
switch
does
not
light
when
Iswitch
on.
No
power
connected.
Check
power
is
connected.
The
power
LED
does
not
light
on
the
remote
contr
ol.
Fuse
on
main
PCB
blown.
Remote
contr
ol
not
connected.
Check
fuse
on
Main
PCB.
Check
connection
of
remote
contr
ol.
The
ready
LED
does
not
light.
even
after
15
minutes.
Stand-by
button
is
not
on.
Sensor
fault
Check
stand-by
button
Contact
JEM
or
your
Distributor
.
No
smoke
output
when
fog
button
is
pr
essed
(r
eady
LED
is
lit).
The
output
knob
is
not
set
corr
ectly
No
fluid
in
fluid
container
.
Turn
output
knob
fully
clockwise.
Replace
fluid
container
.
The
effect
is
not
lasting
long
enough.
Fluid
is
the
wr
ong
grade.
Choose
a
longer
lasting
fluid
(SP)
PAGE 10
MARTIN MANUFACTURING (UK) PLC
ZR12-AL USER GUIDE
MARTIN MANUFACTURING (UK) PLC
Safety
•
•
•
•
•
•
•
•
•
•
Always use a JEM approved fluid, other fluids could be dangerous and could
cause damage to the machine.
Always check the voltage is correct for use with the machine, the voltage
setting is printed on the serial label.
Always read the user guide before operating the machine, smoke machines
need to be operated carefully to avoid risk.
Never touch the nozzle at the front of the machine, the nozzle can stay hot for
up to 10 hours.
Do not remove the cover or attempt to repair a faulty machine, an authorized
JEM dealer should be contacted in the event of a faulty machine.
Always use smoke machines in well ventilated areas, over use could affect
sufferers of asthma or other chest conditions.
Do not use the machine if there is a faulty mains lead or plug, this could be
dangerous.
Never point the output directly at peoples heads, this is a high power smoke
machine.
Always use approved accessories with this machine.
Do not spill fluid over the machine, if fluid is spilt clean with clean water and
contact an approved JEM dealer for advice.
Mains Lead Wiring Instructions
Brown = Live
Blue = Neutral
Green/Yelllow = Earth
Note! This Appliance must be earthed
PAGE 3
