13
How To Change A Pump:
1.
DRAIN ALL FLUID FROM THE SYSTEM FIRST.
2.
DISCONNECT FROM MAINS SUPPLY.
3. Remove
TOP
COVER
.
4. Disconnect the
POWER
wires from the
PUMP
.
5. Disconnect the
BLACK RUBBER FLUID LINE
from the rear of the
PUMP
.
6. Move the fluid line out of the way. (
BE
CAREFUL
OF
FLUID
COMING BACK DOWN THE
PIPE
)
7. Disconnect the
COPPER FLUID LINE
from the front of the pump.
8. Unhook the rear
RUBBER MOUNT
from the pump.
9. Withdraw the pump from the front
RUBBER MOUNT.
10. Remove the
PUMP
from the machine.
11. Remove the
BRASS FITTING
from the front of the
PUMP.
REFITTING:
12. Fit the
BRASS FITTING
to the front of the pump using a
THREAD SEALANT COMPOUND.
13. Fit the new
PUMP
to the
CHASSIS
by inserting the front end first into the
RUBBER MOUNT.
14. Hook the rear mount onto the back of the pump.
15. Reconnect the
BLACK RUBBER PIPE
.
16. Reconnect the
POWER
wires to the
PUMP
–
BROWN INSIDE / BLUE OUTSIDE.
17. Turn machine on and
RE-PRIME
the system.
18. Refit
TOP COVER
.
Summary of Contents for ZR12-AL
