ZR33-DMX USER GUIDE
Introduction
The
features the “HI-MASS” vaporizing system. This consists of a twin
coil system, each supplied with fluid from a high pressure oscillating piston
pump. This guarantees the maximum output from this size of vaporizing system.
Most smoke machines have one vaporizing coil and one pump, the
has
two of each. JEM has also used the best possible overheat protection using our
“DTP” safety device. This was first used on the JEM
with great
success and we have incorporated it on the
. There is also a 9.5
(2.5
US gallons) fluid container to minimize the need to keep refilling.
To allow easy integration with a lighting control system, the
comes with
DMX 512 as standard. This uses a single Channel and controls the output from a
light haze to maximum output. The
also includes a well featured controller,
enabling the user to operate the machine under manual, control or via the timer
settings. The timer has a new feature called x8 mode that allows the timer values
to be multiplied by 8.
The
can be installed using the flying kit supplied with the machine.
This consists of a heavy duty flying bracket, and an optional drip pad available
as an accessory. Once installed, DMX 512
can be used to control
the output.
A ducting kit is available for applications where the effect is needed in an area
away from the
HI-MASS Vaporizing System
Two High Power Piston Pumps
DMX 512 As Standard
Multifunction Remote Controller
“DTP” Safety System
Pump Ramping For Continuous Output
9.5 Litre Fluid Capacity
SMD Electronics
Low Noise Soft Start Pumping
Heavy Duty Construction
Integrated Flying Bracket
ZR33
ZR33
TECHNO-FOG
ZR33
ZR33
ZR33
ZR33.
ZR33
FEATURES
Litre
or the remote
PAGE 2
MARTIN MANUFACTURING (UK) PLC
ZR33-DMX USER GUIDE
ZR33 Ducting Kit
Ducting adaptor
Jubilee clip
Ducting pipe
The JEM ZR33 ducting kit enables the user to duct the smoke from the
machine to an area where the effect is required. This is done by using the JEM
ducting adaptor and a length of 100 mm (4“) ducting pipe. The length can be
anything from a couple of metres up to 20 metres or further. There are one or
two things to beware of when using smoke machines with ducting, firstly if there
are bends to redirect the smoke they could cause condensation to form also an
air space must be provided between the output of the machine and the ducting
adaptor.
NOTE! Always use the recommended ducting adaptor and ducting
pipe, others may cause damage to the machine.
PAGE 11
MARTIN MANUFACTURING (UK) PLC
