ZR33-DMX USER GUIDE
Using The Remote Control
Fog Button
Stand-by Button
Timer Value Button
Timer Engage Button
Output Control
Power LED
Delay Time Control
Timer Cycle LED
Run Time Control
The
comes with a comprehensive controller that allows the user to
manually fire the machine, or set a well featured timer to operate the
machine automatically. When the “ready” LED is lit at the rear of the
machine the remote becomes functional and the “fog” button will operate
the machine when pressed. Sometimes a pre-determined amount of smoke is
needed and the
remote has a timer that will operate over a wide
range or varying times. The x8 timer value gives even greater flexibility
when a longer delay and run time are needed.
ZR33
ZR33
PAGE 6
MARTIN MANUFACTURING (UK) PLC
ON
TIMER
ON
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
6
6
6
7
7
7
8
8
8
9
9
9
POWER
CYCLE
MUL
TI-FUNCTION
CONTROLLER
OUTPUT
DELAY
RUN
FOG
x8
STAND-BY
ON
ZR33-DMX USER GUIDE
Functions
FOG BUTTON: Will when the machine has reached operating temperature fire
the machine when pressed and held.
STAND-BY BUTTON: This turns the machines electronics on and off.
TIMER VALUE BUTTON: When the timer is being used, the timer values can be
adjusted by a factor of 8, i.e. a 5 second minimum run time becomes 40 seconds &
a 10 second delay time becomes 1 minute 20 seconds.
TIMER ENGAGE: This will engage the timer to fire the machine according to the
present settings.
OUTPUT CONTROL: Turning this knob clockwise will increase the output of the
machine, if turned fully anti-clockwise there will be no output.
DELAY TIME CONTROL: This will adjust the amount of time the machine waits
between operating when the timer is engaged.
RUN TIME CONTROL: This will adjust the time the machine will operate for
when the timer is engaged.
POWER LED: This LED will light when the machine is switched on
CYCLE LED: This LED will light when the timer is engaged and the machine is
operating.
Timer Values
Maximum = 18 seconds
Minimum = 2 seconds
Run Time: X1 mode
Maximum = 2 minutes 24 seconds
Minimum = 16 seconds
Run Time: X8 mode
Maximum = 18 seconds
Minimum = 2 seconds
Delay Time: X1 mode
Maximum = 2 minutes 24 seconds
Minimum = 16 seconds
Delay Time: X8 mode
An extension lead is available from JEM for using the controller out of
the machine.
PAGE 7
MARTIN MANUFACTURING (UK) PLC