Jema Autolifte – Denmark
- WE ARE HERE TO SURPRISE!
12
Step sixteen: install the cover plate
3.4 Check list after installation
S/N
Check items
YES NO
1
If the columns is vertical to the floor
2
If the two posts are horizontal
3
If the oil hose connection is correct
4
If the wire rope connection is correct
5
If the arm is fastening
6
If the wiring is correct
7
If the other joints are tightened
4. Operation instruction
4.1 Precautions during operation
Remark: Only authorized staff can adjust the system pressure on the power unit.
4.1.1
Check all the pipelines and joints before use. The machine only can be used after there is not any leakage.
4.1.2
The lift, if its safety device malfunctions, shall not be used.
4.1.3
The machine shall not lift or lower an automobile if the center of gravity of automobile is not within the supporting range of
the supporting device. Otherwise, the manufacturer will not bear any responsibility for the consequence resulted from the
operation above mentioned.
4.1.4
The staff or operators shall be in a safe position when the machine lift or lower.
4.1.5
When the lift with vehicle on reaches a desired height, first of all, the main switch must be turned off before the
automobile is repaired so as to prevent non-operator or unauthorized person from pressing the start switch.
4.1.6
. Always lock the lift by pressing handle on power unit before going under the vehicle. Never allow anyone to go under the
lift when raising or lowering.
Summary of Contents for JA3500T
Page 20: ...Jema Autolifte Denmark WE ARE HERE TO SURPRISE 20 ANNEX 2 Overall Diagram ...
Page 22: ...Jema Autolifte Denmark WE ARE HERE TO SURPRISE 22 Annex5 Wiring diagram Single phase ...
Page 31: ...Jema Autolifte Denmark WE ARE HERE TO SURPRISE 31 ...
Page 32: ...Jema Autolifte Denmark WE ARE HERE TO SURPRISE 32 ...
