7)
Fire it up! Directions for the controller are included separately. A quick start guide can be
found below.
Never Leave a Firing Kiln Unattended!
For the ProFusion 16 we use a faster fusing program such as 500
⁰
F per hour to 1000
⁰
F and hold 0
minutes, then as fast as possible to 1500
⁰
F and hold 10 minutes, then as fast as possible to anneal
the glass at 950
⁰
F for 30 minutes and then off. Below are the steps to enter this program.
Your controller contains 4 pre-programmed options, but let’s put in your first QUICK-FIRING
schedule. This first program is to FULL FUSE for small pieces. Next you will see what is to be
entered.
Rate 1 500 degrees per hour
Degrees F 1 1500
⁰
F temperature going to
Hold 1/ 0 min hold time in hours and minutes
Rate 2 FULL
Degrees F 2 950
⁰
F
Hold 2 30 min
Rate 3
0 to end the program
Never Leave a Firing Kiln Unattended!
A good home test for stress in the finished glass: Put finished pieces in the freezer. Take them out
and run HOT tap water over them. If they don't break, they are stress free!
Call if you need help, and thank you for using one of our kilns. Go and make great things.
Jen-Ken Kilns
863-648-0585 M-F 8-4 Eastern
Copywrite©2015 Jen-Ken Kilns
