2.2.4 Fitting the MIDI Socket
□
Decide where you want to fit the MIDI socket. The recommended location is the bottom
right corner of the rear panel (looking at it from the back).
□
Drill a single
15
mm diameter hole in the rear panel, plus two 3mm diameter holes each
side to match the socket supplied.
□
Fit the MIDI socket into the rear panel using the two black screws provided.
2.2.5 Connecting the Filter Cutoff
□
Solder the single wire from the MIDI Upgrade board to the filter CV mixer. A good place
is on the left lead of the resistor as shown in the picture below.
-
9
-
