NOTE : Check the pump pressure
from the pressure gauge on the
pump during the initial filling. The
pressure should be between
1-3
bars
depending on the steam
generator capacity. If higher
pressures are encountered, this is
a precursor to the formation of
blockage in the coil.
Gl
iserinli
P
o
mp
a Manome
tr
esi
7
–
You should see water coming from
the outlet of the trap by-pass valve.
8 - Once you have seen the water coming in, set
the pump switch on the control panel to the
normal operating position (
OTOMATİK
).
32
Summary of Contents for SHS Series
