Learning to Use the Lean Clean 360 Cleaning System
31
Operating the Lean Clean
Once the machine and oil separator (if installed) are ready to operate, follow
these steps to clean parts:
1.
Press the
Program
button on the main operating screen and select the
program you want to run. Press
Enter
then
Done
.
2.
Load the basket of parts into the washing chamber and close the
door (Figure 9).
3.
Set the rotator speed using the rotator speed knob on the control
panel.
4.
The green
Start
light should be flashing indicating the machine is ready
to run. To start the washing cycle, press the
Start
button.
5.
At the end of the cleaning cycle, the red
Stop
light will continue to
flash. Press the
Stop
button.
6.
Open the washing chamber door and remove the basket of parts.
Figure 9. Loading a basket into the Lean Clean
