99
Test mode :
To test your device (electronic circuit),
press and hold down the “test” button.
This activates the alarm mode: the red light
flashes and the alarm rings. Release the
button to stop the test. The “Fault” light
switches on in case of any malfunctioning.
In this case, please contact our customer
service department.
Setting
After the installation, the detector is automatically connected to the Jenile flashes
and vibrators. Warning, if you press too long on the CBM cube plug, it will be
disconnected. Press on the test button to activate the alarm, then the LED flashes
quickly and it transmits the signal to Jenile wireless flash receivers or vibrators.
Care
It is recommended to test the detector every week (cf test mode) and clean the
openings in the event of dust being present.
Instructions in case of alarm
Open the doors and windows to ventilate the room
Switch off any source of ignition (flame, spark)
Leave the premises
Do not switch on the light, even at night
Do not touch any power switch or circuit breaker
Do not call from your place neither from your fixed line nor from your cellphone
Use the staircase rather than the lift and do not switch on the light
Do not ring your neighbour but knock the door
Call the firemen and/or specialised services
