To use the HI-TEMP ALARM for a spa/hot tub, the probe must be installed in the
filter circulation system on the suction side of the pump. If the system is valved for the
skimmer and main drain, be sure to use the main drain pipe or after the two lines are teed
together.
The probe is installed in a well. ( Not supplied with alarm) The well is installed in the
run of the tee, bushing down to 1/2 inch F.I.P.
Note:
If display reads 3.XX(X=any number), wire leads on Terminals #3 and #4 are
reversed.
1 2 3 4 5 6 7
display
Transformer
blue
To probe
relay
t
o
power
Control
Circuit
120v. (red & black)
240v. (red & red)
JENISSE LEISURE PRODUCTS, INC.
5 Van Duyne Court
TOWACO, NJ 07082
Phone: 973/331-1177 Fax: 973/331-1136
c.5/1/2001
