P A L E R T A N D P X - 0 1 S Y S T E M S W E B
C O N F I G U R A T I O N
USER MANUAL
Jenlogix
Version 2 26/01/2018
© Jenlogix 2017 Jenlogix
Page 35 of 46
5. ACCESS OPERATING SYSTEM
To do underlying changes to the operating system configuration requires using terminal access. This can be
done with a product like Putty. Instructions as below.
5.1
INSTALL PUTTY OR SIM ILAR ON
A LAPTOP
Change laptop IP to same newtwork as device
(192.168.255.xx - 20 as example).
Connect laptop to Device with normal Ethernet cable
Run putty and connect using SSH to IP address of unit
Accept security warning message
5.2
PASSW ORD CHANGE
Using PUTTY login to the unit with the pi / 1111 default user
and password.
At prompt type
passwd
Enter existing password
Then enter new password twice. This will need to be failry complex and not similar to previous as there are
password policies embedded in the system.
Type exit to leave system