7
Install the Door
IMPORTANT: To ensure proper operation, be sure to grease the
top hinge, top spacer and washer with petroleum jelly.
1. Using a Phillips screwdriver and three screws, attach the top
spacer to the door.
2. Using petroleum jelly, grease the bottom spacer hole and the
bottom hinge pin. Align the washer with the bottom spacer
hole.
3. Install the door by inserting the bottom hinge pin into the
bottom spacer hole. Be sure the washer remains in place.
Slowly lower the door straight and evenly onto the bottom
hinge pin. Close the door. Be sure the door properly aligns to
the cabinet.
NOTE: Provide additional support for the door when moving
the hinges. Do not depend on the door magnets to hold the
door in place while you are working.
4. Using masking tape, secure the door to the cabinet before
installing the top spacer as shown.
5. Place the washer on the top spacer and align the holes.
Grease the top hinge pin, top spacer and washer with
petroleum jelly. Insert the top hinge pin into the washer and
top spacer.
6. Using a Phillips screwdriver and three screws, attach the top
hinge to the cabinet as shown.
7. Remove the masking tape from the door.
Door Closing
Door Closing
Your refrigerator has four leveling legs. If your refrigerator seems
unsteady or you want the door to close more easily, adjust the
refrigerator’s tilt using the instructions below.
1. Plug into a grounded 3 prong outlet.
2. Move the refrigerator into its final location.
3. Turn the leveling legs to the right to lower the refrigerator or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling legs. This
makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both front leveling screws to the left. It may take
several more turns, and you should turn both leveling legs the
same amount.
A. Top spacer
B. Masking tape
A. Screws (3)
B. Top hinge
C. Washer
D. Top spacer
E. Door
F. Overlay panel
A
B
C
D
E
A
B
F
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
