Jenn-Air JCD2295KEP, Use & Care Manual

9

I

NSTALLATION

Leveling

To protect personal property and refrigerator from
damage, observe the following:

• Protect vinyl or other flooring with cardboard, rugs,

or other protective material.

• Do not use power tools when performing leveling

procedure.

CAUTION

To enhance the appearance and maintain performance,
the refrigerator should be level.

Note

• Complete any required door reversal, panel

installation and/or a water supply connection,
before leveling.

5. Using the carpenter’s level, make sure front of

refrigerator is 

1

⁄

4

” (6 mm) or 

1

⁄

2

bubble higher than

back of refrigerator and that the refrigerator is level
from side to side.

6. If required, correct rocking of refrigerator by

turning rear adjustment screw clockwise to raise
rocking corner. If doors are uneven, do the
following:

• Determine which

door needs to be
raised.

• Turn front roller

adjustment screw (A)
clockwise to raise
front corner of door.

• If one refrigerator door has reached the limit of

its adjustment range and doors are still not level,
lower the opposite door by turning roller
adjustment screw counterclockwise.

• Check with level to verify 

1

⁄

4

” tilt to the back for

proper door closure.

• If refrigerator is aligned and stable, replace toe

grille and hinge covers.

7. Replace hinge cover(s).

• Position cover into the outer edge of the hinge.

• Swing the cover toward the cabinet and snap it

into place.

8. Replace the toe grille.

A

B

A B

4. Turn both rear adjustment screws (B) clockwise to

raise and counterclockwise to lower the rear of the
refrigerator.

Materials Needed

•

3

⁄

8

” hex head driver

• Carpenter’s level

1. Remove toe grille.

• Grasp firmly and pull bottom

outward to unclip.

2. Remove bottom hinge cover(s).

• Place the eraser end of a pencil or similar blunt

tool in the cover notch.

Notch

Location

• Use slight pressure to pry the

cover loose.

• Continue to maintain

downward pressure to the
notched side of the cover while
swinging it off.

3. Using hex head driver, turn both of the front

adjustment screws (A) clockwise to raise and
counterclockwise to lower the front of the
refrigerator.

Note

• For proper reinstallation, ensure the “top” marking

on the interior of the toe grille is oriented correctly.

• Align the toe grille mounting clips with the lower

cabinet slots.

• Push the toe grille firmly until it snaps into place.