Jenn-Air JCD2295KEP, Use & Care Manual

3

I

NSTALLATION

Location

• Do not install refrigerator near oven, radiator or other

heat source. If not possible, shield refrigerator with
cabinet material.

• Do not install where temperature falls below 55° F

(13° C) or rises above 110° F (43° C). Malfunction
may occur at this temperature.

•

Refrigerator is designed for indoor household
application only.

Measuring the Opening

When installing your refrigerator, allow 

1

⁄

2

” space at top

and 

1

⁄

2

” space behind machine compartment cover

(located in the rear) for proper air circulation. If the
refrigerator is placed with the door hinge side against
a wall, you may want to allow additional space so the
door can be opened wider.

Subflooring or floor coverings (i.e. carpet, tile, wood
floors, rugs) may make your opening smaller than
anticipated.

Some clearance may be gained by using the leveling
procedure under 

Leveling

.

IMPORTANT:

If refrigerator is to be installed into a

recess where the top of the refrigerator is completely
covered, use dimensions from floor to top of hinge cap
to verify proper clearance.

Transporting Your Refrigerator

•

NEVER

transport refrigerator on its side. If an

upright position is not possible, lay refrigerator on its
back. Allow refrigerator to sit upright for
approximately 30 minutes before plugging it in to
assure oil returns to the compressor. Plugging
refrigerator in immediately may cause damage to
internal parts.

Glass Panel Doors

(select models)

To avoid possible injury, product or property damage,
observe the following:

• When working directly on the doors, protect the

door corners and sides by placing doors on a
nonabrasive surface protected by towels or rugs.

• Protect the glass panel sides when securing the

unit to a dolly.  DO NOT OVERTIGHTEN!  Over
tightening the restraints may shatter the glass
which could cause personal injury.

• DO NOT carry or transport removed doors by the

handles.

• Fully tighten handle set screws when installing the

door handles.

• Another bullet coming - save space

CAUTION

• Use an appliance dolly when moving refrigerator.

ALWAYS

truck refrigerator from its side or

back–

NEVER

from its front.

• Protect outside finish of refrigerator during transport

by wrapping cabinet in blankets or inserting padding
between the refrigerator and dolly.

• Secure refrigerator to dolly firmly with straps or

bungee cords. Thread straps through handles when
possible. Do not overtighten. Overtightening
restraints may dent or damage outside finish.