Jenn-Air JCD2295KEP, Use & Care Manual

I

NSTALLATION

5

1. Create service loop with copper

tubing (minimum 2' diameter).
Avoid kinks in the copper tubing
when bending the service loop.
Do not use plastic tubing.

2. Remove plastic cap from water valve

inlet port.

3. Place brass nut (A) and sleeve (B) on

copper tube end as illustrated. (Do not
use old sleeve.) Brass nut (A) and
sleeve (B) are provided
in the refrigerator Use
and Care guide packet.

4. Place end of copper

tubing into water valve
inlet port. Shape tubing
slightly. Do not kink – so that tubing
feeds straight into inlet port.

5. Slide brass nut over sleeve and screw nut

into inlet port. Tighten nut with wrench.

IMPORTANT: 

Do not overtighten. Cross

threading may occur.

6. Pull on tubing to confirm connection is

secure. Connect tubing to frame with
water tubing clamp (C) and turn on
water supply. Check for leaks and
correct if necessary. Continue to observe
the water supply connection for two to
three hours prior to moving the
refrigerator to its permanent location.

7. Monitor water connection for 24 hours.

Correct leaks, if necessary.

C

A

B

2' diameter

minimum

Materials Needed

•

1

⁄

4

” outer diameter flexible copper tubing 

• Shut-off valve (requires a 

1

⁄

4

” hole to be drilled into

water supply line before valve attachment)

• Adjustable wrench
•

1

⁄

4

” hex nut driver

Note

• Add 8' to tubing length needed to reach water

supply for creation of service loop.

Connecting the Water Supply

(select models)

To avoid property damage or possible injury,
follow basic precautions, including the
following:

• Consult a plumber to connect 

1

⁄

4

” O.D. copper

tubing

to household plumbing to assure

compliance with local codes and ordinances.

• Confirm water pressure to water valve is between

35 and 100 pounds per square inch, 20 pounds
per square inch without filter.

• Do not use a self-piercing, or 

3

⁄

16

” saddle valve.

Both reduce water flow can become clogged over
time, and may cause leaks if repair is attempted.

• Wait two to three hours before placing refrigerator

into final position to check and correct any water
leaks. Recheck for leaks after 24 hours.

• Verify the copper tubing under the sleeve is

smooth and free from defects. Do not reuse an old
sleeve.

CAUTION

To reduce risk of injury or death, follow basic
precautions, including the following:

• Read all instructions before installing ice maker.
• Do not attempt installation if instructions are not

understood or if they are beyond personal skill
level.

• Observe all local codes and ordinances.
• Do not service ice maker unless specifically

recommended in Use & Care Guide or published
user-repair instructions.

• Disconnect power to refrigerator before installing

ice maker.

• Water damage due to an improper water

connection may cause mold/mildew growth. Clean
up spills or leakage immediately.

WARNING