-16-
BURNER CAPS AND SEALED
GAS BURNERS
S
Allow burner to cool. Remove burner cap and wash in
soapy water with a plastic scouring pad or in the
dishwasher. For stubborn soils, clean with a soap-filled,
nonabrasive pad or Cooktop Cleaning Creme (Part
#20000001).
S
For burned on soil, place burner cap on newspaper and
spray with commercial oven cleaner. Follow
manufacturer’s directions.
S
Clean gas ports with a straight pin especially the port
below the ignitor. Do not enlarge or distort holes.
S
Be careful not to get water into burner ports.
S
When cleaning, use care to prevent damage to the
ignitor. If the ignitor is soiled, wet or damaged the
surface burner will not light.
HOW TO REMOVE RANGE FOR
CLEANING AND SERVICING
Follow these procedures to remove appliance for
cleaning or servicing:
1. Shut off gas supply to appliance.
2. Disconnect electrical supply to appliance, if equipped.
3. Disconnect gas supply tubing to appliance.
4. Slide range forward to disengage range from the
anti-tip bracket. (See page 5).
5. Reverse procedure to reinstall. If gas line has been
disconnected, check for gas leaks after reconnection.
NOTE:
A qualified servicer should disconnect and
reconnect the gas supply.
6. To prevent range from accidentally tipping, range must
be secured to the floor by sliding rear leveling leg into
the anti-tip bracket.
