Troubleshooting Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless
testing requires power.
©2005 Maytag Services
16025927
11
Problem Possible
Cause
Correction
Self-clean cycle not
working
Programming error .....................................
Door lock ....................................................
•
Turn off circuit breaker for five minutes
and try oven again.
•
Verify door lock energizes & engages.
Frequent cycling of
surface element or
warming zone
Normal........................................................
•
Element cycles to maintain proper heat
and to prevent damage to smoothtop.
Fault Code Chart
Fault Code
Description
Component to Troubleshoot/Replace
F0-0 No
Fault......................................................
•
None.
F1-1
Oven temperature above 650° F
(343° C) in bake mode ...............................
•
Ohm sensor and harness (see
"
Oven
Sensor
"
chart). If OK, change control.
F1-3
Oven temperature above 950° F
(510° C) during a clean cycle .....................
•
Ohm sensor and harness (see
"
Oven
Sensor
"
chart). If OK, change control.
F1-5
Cancel pad not responding ........................
•
Ensure ribbon cable is securely
connected, inspect ribbon cable and
connector (shorts, breakage, corrosion,
etc.). If OK, replace control.
F1-7 Membrane
disconnected............................
•
Ensure ribbon cable is securely
connected, inspect ribbon cable and
connector (shorts, breakage, corrosion,
etc.). If OK, replace control.
F1-8
Shorted key (pad) in membrane switch .....
•
Ensure ribbon cable is securely
connected, inspect ribbon cable and
connector (shorts, breakage, corrosion,
etc.). If OK, replace control.
F1-9
Internal control communication errors........
•
Replace control.
F1-A
Lock/unlock switch state not advancing
to control.....................................................
•
Check connections, harness, and
motor. If OK, replace control.
F1-C
Oven door switch state not advancing to
control.........................................................
•
Check connections, harness, and
motor. If OK, replace control.
F1-E
Control not calibrated .................................
•
Replace control.
F1-F
Jumper not removed from printed circuit
board (PCB) ...............................................
•
Remove jumper from PCB.
F1-H EEPROM
error ...........................................
•
Replace control.
F1-N
Internal voltage for slave micro incorrect ...
•
Replace control.
F3-1
Open or shorted sensor .............................
•
Ohm sensor and harness.
F8
Shorted meat probe ...................................
•
Check probe jack and harness probe
jack harness. If OK, check meat probe
(see
"
Meat Probe
"
chart).
F9-1
Oven door will not lock ...............................
•
Check wire connections. If OK,
replace motorized door lock.
F9-2
Oven door will not unlock ...........................
•
Check wire connections. If OK,
replace motorized door lock.
F9-3
Oven door status is both locked and
unlocked .....................................................
•
Check wire connections. If OK,
replace motorized door lock.
