15
Complete Installation
1.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Check that you have all of the range accessories, especially
oven racks. These accessories may be in the range
packaging.
4.
Dispose of/recycle all packaging materials.
5.
Check that the range is level. See the “Level Range” section.
6.
Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, see the
“Range Maintenance and Care” section.
7.
Read the Quick Start Guide and online Control Guide.
8.
Plug power cord into appropriate outlet. Turn power on.
9.
Turn on surface burners and oven. See the Quick Start Guide
and online Control Guide for specific instructions on range
operation.
NOTE:
Odors and smoke are normal when the oven is used
the first few times.
If Range Does Not Operate, Check the Following:
�
Household fuse is intact and tight; or circuit breaker has
not tripped.
�
Range is plugged into a grounded outlet.
�
Electrical supply is connected.
IMPORTANT:
If the range control displays an “F9” or “F9,
E0” error code, the electrical outlet in the home may be
miswired. Disconnect power and contact a qualified
electrician to verify the electrical supply.
10.
When the range has been on for 5 minutes, check for heat. If
the range is cold, turn off the range and contact a qualified
electrician.
If You Need Assistance or Service:
Please reference the Quick Start Guide for contact information.
Moving the Range
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to
avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1.
Slide range forward.
2.
Unplug the power supply cord.
3.
Complete cleaning or maintenance.
4.
Plug in power supply cord.
5.
Check that the anti-tip bracket is installed and engaged. See
the “Verify Anti-Tip Bracket Is Installed and Engaged” section.
6.
Check that range is level.
For direct-wired ranges:
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.
Disconnect power.
2.
Slide range forward.
3.
Complete cleaning or maintenance.
4.
Check that the anti-tip bracket is installed and engaged. See
the “Verify Anti-Tip Bracket Is Installed and Engaged” section.
5.
Check that range is level.
6.
Reconnect power.
