6
A
A. Power switch
Using the Controls
IMPORTANT:
■
The refrigerator control adjusts the refrigerator compartment
temperature. The freezer control adjusts the freezer
compartment temperature.
■
Wait 24 hours after you turn on the refrigerator before you put
food into it. If you add food before the refrigerator has cooled
completely, your food may spoil.
NOTE:
Adjusting the refrigerator and freezer controls to a
lower (colder) setting will not cool the compartments any
faster.
■
If the temperature is too warm or too cold in the refrigerator
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
■
The preset settings should be correct for normal household
usage. The controls are set correctly when milk or juice is as
cold as you like and when ice cream is firm.
■
The actual temperature may differ from the display when a
door is open for an extended period of time.
NOTE:
The factory recommended set points are 0°F (-18°C) for
the freezer and 37°F (3°C) for the refrigerator.
REFRIGERATOR USE
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
Power On/Off Switch
If you need to turn the power to your refrigerator On or Off,
you must remove the top grille assembly to access the power
switch. Turn the power to the refrigerator Off when cleaning your
refrigerator.
Standard Installation - Flush Grille
To remove the top grille panel:
1.
Open the door(s).
2.
Lift the top grille panel straight up, and then pull straight out.
Place the panel on a soft surface.
To replace the top grille panel:
1.
Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
2.
Pull the grille panel down slightly to lock into place.
Integrated Installation - Full Height Grille
To install the grille panel to the refrigerator:
1.
Slide the upper and lower slots in each bracket onto
the mounting pins extending upward from the top of the
refrigerator.
2.
Push the grille panel forward to fully engage the spring clips
and fasten the grille panel.
To remove the grille panel from the refrigerator:
1.
Open the door(s).
2.
Place both hands under the grille panel, grasping the bottom
edge between your fingers and thumbs.
3.
Pull the grille panel straight out until the grille stops. Then, lift
up on the grille panel to remove.
Turn Power On or Off:
1.
Remove top grille.
2.
Press Power switch to the ON or OFF position.
3.
Replace top grille.
IMPORTANT:
Be sure the power switch is set to the ON position
after cleaning refrigerator or changing light bulbs.
