4
• To prevent injury,
one person should not attempt to
tilt the wine chiller by himself. Have someone else
assist to prevent the wine chiller from falling during
leveling leg installation.
WARNING
Dimensions
Leveling Legs
Install leveling legs (located in literature pack):
• With at least two people, tip wine chiller backwards
until there is approximately 12" (31 cm) of clearance
between the floor and the wine chiller.
• Screw one front leveling leg into the screw
impression found in each corner. Leveling legs
should be screwed in until snug.
• Repeat the above procedures to install the rear
leveling legs.
• The wine chiller should remain upright at least
30 minutes prior to plugging it in.
CAUTION
Level the Wine Chiller
Using a carpenter’s level, check to be sure the wine
chiller is level from side to side and from front to back.
Leveling adjustments can be made by turning the
leveling legs counter-clockwise to increase height and
clockwise to reduce height.
NOTE:
The wine chiller should not wobble. Use shims
to add stability when needed.
3"
(7.6 cm)
min. 34"
(86.4 cm)
max. 35"
(88.9 cm)
with
leveling
legs fully
extended
47
1
⁄
4
"
(120.0 cm)
Side
22"
(55.9 cm)
24
1
⁄
4
"
(61.6 cm)
Bottom of
wine chiller
Weldnut
(each bottom
corner of unit)
Leveling leg
(4 per wine chiller)
23
7
⁄
8
"
(60.6 cm)
Front
