Jenn-Air JUCFP242HXPA, Use And Care Manual And Installation Instructions

11

4. 

The ice maker is equipped with a built-in water 

strainer. If your water conditions require a second 

water strainer, install it in the 1/4" (6 mm) water line at 

either tube connection. Obtain a water strainer from 

your nearest appliance dealer.

5. 

Plug in refrigerator drawers or reconnect power.

MOVE THE REFRIGERATOR DRAWERS TO 

FINAL LOCATION

1. 

Place top of cardboard carton or plywood under the 

appliance. Remove dolly.

2. 

Do not remove film or cover.

3. 

Plug into a grounded 3 prong outlet.

4. 

Move the refrigerator drawers straight back and 

evenly in front of the opening.

INSTALL CUSTOM OVERLAY PANEL

IMPORTANT:

For standard stainless steel models, skip these 

instructions and go to "LEVEL THE REFRIGERATOR 

DRAWERS" section.

Create a custom overlay panel according to the 

specifications in “Custom Overlay Drawer Panels.”

JennAir is not responsible for the removal or addition 

of molding or decorative panels that would not allow 

access to the refrigerator drawers for service.

ATTACH THE OVERLAY PANEL
NOTE: If the overlay hooks are not installed, see “Custom 

Overlay Drawer Panels” for overlay hook locations. The 

location of the hooks must be as precise as possible. If 

the custom panel is incorrectly placed, the panel may 

interfere with optimal use of the drawers.

1. 

Attach the custom handle of your preference on the 

overlay before attaching the overlay to the drawer of 

the refrigerator.

NOTE: Custom handles may vary in dimensions. Holes 

must be made on the panel according to the specific 

dimensions of your handle.

2. 

Attach the hooks to their corresponding recessions 

on the panel, using the SS Flat M4x12 screws. Two 

screws are needed per hook. The hooks must be on 

the outer edge 

of the panel.

3. 

Gently pull back the gasket from the top corners of 

the door until you can see the screw that is behind 

the gasket. There is one screw on each side. It is not 

necessary to remove the gasket.

4. 

Remove the screws behind the gasket (one per side).

5. 

Align the panel to the drawer and position the overlay 

panel 1/2" (12.5 mm) higher than the door. Position 

the overlay hooks with the pilot holes and push the 

hooks into the holes. The drawer has insulant foam 

in its interior so you may feel some interference while 

pushing. Push until the hooks go through the foam.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, 
fire, or electrical shock.

WARNING