Jenn-Air JUCFP242HXPA, Use And Care Manual And Installation Instructions

9

ELECTRICAL REQUIREMENTS

Before you move your refrigerator drawers into its final 

location, it is important to make sure you have the proper 

electrical connection.
RECOMMENDED GROUNDING METHOD
A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded 

electrical supply is required. It is recommended that a 

separate circuit serving only your refrigerator drawers be 

provided. Use an outlet that cannot be turned off by a 

switch. Do not use an extension cord.
NOTE: Before performing any type of installation, 

cleaning, or removing a light bulb, unplug refrigerator 

drawers or disconnect power.

WATER SUPPLY REQUIREMENTS 

(REFRIGERATOR/FREEZER DRAWERS 

ONLY)

Gather the required tools and parts before starting 

installation. Read and follow the instructions provided 

with any tools listed here.
IMPORTANT:

Connect to potable water supply.

If you turn ON the refrigerator drawers before the 

water line is connected, turn OFF the ice maker.

All installations must meet local plumbing code 

requirements.

Use copper tubing and check for leaks. Install 

copper tubing only in areas where the household 

temperatures will remain above freezing.

TOOLS NEEDED: Flat-blade screwdriver, 7/16" and 1/2" 

open-end wrenches or two adjustable wrenches, 1/4" nut 

driver and drill bit, cordless drill.
NOTE: Your refrigerator dealer has a kit available with a 

1/4" (6 mm) saddle-type shutoff valve, a union, and copper 

tubing. Before purchasing, make sure a saddle-type valve 

complies with your local plumbing codes. Do not use 

a piercing-type or 3/16" (4.76 mm) saddle valve which 

reduces water flow and clogs more easily.
WATER PRESSURE
A cold water supply with water pressure of between 30 

and 120 psi (207 and 827 kPa) is required to operate ice 

maker. If you have questions about your water pressure, 

call a licensed, qualified plumber.
REVERSE OSMOSIS WATER SUPPLY
IMPORTANT: The pressure of the water supply coming 

out of a reverse osmosis system going to the water inlet 

valve of the refrigerator needs to be between 30 and 120 

psi (207 and 827 kPa).
If a reverse osmosis water filtration system is connected 

to your cold water supply, the water pressure to the 

reverse osmosis system needs to be a minimum of 40 to 

60 psi (276 to 414 kPa).
If the water pressure to the reverse osmosis system is less 

than 40 to 60 psi (276 to 414 kPa):

Check to see whether the sediment filter in the 

reverse osmosis system is blocked. Replace the filter if 

necessary.

Allow the storage tank on the reverse osmosis system 

to refill after heavy usage.

If you have questions about your water pressure, call a 

licensed, qualified plumber.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, 
fire, or electrical shock.

WARNING

Do not use with water that is microbiologically unsafe or 

of unknown quality without adequate disinfection before 

or after the system. Systems certified for cyst reduction 

may be used on disinfected waters that may contain 

filterable cysts.