Jenn-Air JUGFR242HM00, Use And Care Manual And Installation Instructions

12

9. 

Auto Light (Glass Door Models)

The refrigerator has a sensor that will turn on the 

interior display light automatically when someone 

walks by. When motion is no longer detected, the 

interior display light will go off after 2 minutes.

Press the Auto Light option to activate this 

feature.

When the Auto Light is not activated, the interior 

display light will only turn on when the door is 

opened.

NOTE:

Leaving the light on for an extended period of 

time will slightly increase the temperature of the 

refrigerator.

10. 

Door Open Alarm

Helps avoid food from spoiling by giving an audio and 

visual alert if the door is left open for 10 minutes.
If the door is open longer than 10 minutes, an alarm 

will sound every 2 minutes until the door is closed or 

any control is pressed.

11. 

Showroom Mode

This mode is used only when the refrigerator is on 

display in a retail store. If you unintentionally turn on 

Showroom Mode, Cool Off will light up on the display, 

and the controls will appear to work. Exit Showroom 

Mode by pressing and holding COOL ON and 

SABBATH at the same time for 3 seconds.

NORMAL SOUNDS

Your new refrigerator may make sounds that your old 

one didn’t make. Because the sounds are new to you, 

you might be concerned about them. Most of the new 

sounds are normal. Hard surfaces, such as the flooring 

and surrounding structures, can make the sounds seem 

louder. The following describes the kinds of sounds and 

what may be making them.

Your refrigerator is designed to run more efficiently 

to keep your food at the desired temperatures 

and to minimize energy usage. The high efficiency 

compressor and fans may cause your refrigerator 

to run longer than your old one. You may also 

hear a pulsating or high-pitched sound from 

the compressor or fans adjusting to optimize 

performance.

Rattling noises may come from the flow of refrigerant 

or items stored inside the refrigerator.

As each cycle ends, you may hear a gurgling sound 

due to the refrigerant flowing in your refrigerator.

You may hear water running into the drain pan when 

the refrigerator is defrosting.

You may hear clicking sounds when the refrigerator 

starts or stops running.

REFRIGERATOR SHELVES

TO REMOVE OR ADJUST UPPER SHELVES:

1. 

Remove the shelf by lifting it up and out of the shelf 

brackets.

2. 

Remove the two shelf brackets and reposition them 

in the desired location.

3. 

Replace the shelf by inserting it into the shelf 

brackets.

NOTE:

 Be sure the shelf is level.

TO REMOVE AND REPLACE BOTTOM SHELF:

1. 

The very bottom glass shelf slides straight out.

2. 

Replace the shelf by aligning the edges with the 

guides and pushing it in toward the back of the 

refrigerator.