11
11
11
DOOR FEATURES
Door Bins
Your refrigerator has two door bin locations for maximum storage
capacity.
To Remove and Replace the Door Bins:
1.
Remove the door bin by tilting it forward and pulling it out.
2.
Replace the bin by placing the rear of the bin under the
support on the door and sliding into place.
Lighting the Refrigerator
The refrigerator has an interior light that comes on any time the
door is opened.
NOTE:
The light is an LED which does not need to be replaced. If
the LED does not illuminate when the door is opened, call Service
to replace the light. See Assistance or Service for contact
information.
REFRIGERATOR CARE
Base Grille
You must remove the base grille to access the condenser coils
for cleaning.
To Remove the Base Grille:
1.
Open the refrigerator door.
2.
Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the refrigerator.
3.
Remove the base grille.
To Replace the Base Grille:
1.
Open the refrigerator door.
2.
Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.
Cleaning
Clean the refrigerator about once a month to avoid buildup of
odors. Wipe up spills immediately.
To Clean Your Refrigerator:
1.
Unplug refrigerator or disconnect power.
2.
Remove all removable parts from inside, such as shelves, etc.
3.
Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
■
Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning
waxes, concentrated detergents, bleaches or cleansers
containing petroleum products on plastic parts, interior
and door liners or gaskets. Do not use paper towels,
scouring pads, or other harsh cleaning tools. These can
scratch or damage materials.
■
To help remove odors, you can wash interior walls with a
mixture of warm water and baking soda (2 tbs to 1 qt
[26 g to 0.95 L] of water).
4.
Wash stainless steel and painted metal exteriors with a clean
sponge or soft cloth and a mild detergent in warm water. Do
not use abrasive or harsh cleaners, or cleaners containing
chlorine. These can scratch or damage materials. Dry
thoroughly with a soft cloth.
NOTE:
To keep your stainless steel refrigerator looking like
new and to remove minor scuffs or marks, it is suggested that
you use the manufacturer’s approved Stainless Steel Cleaner
and Polish.
IMPORTANT:
This cleaner is for stainless steel parts only!
Do not allow the Stainless Steel Cleaner and Polish to come
into contact with any plastic parts such as the trim pieces,
dispenser covers or door gaskets. If unintentional contact
does occur, clean plastic part with a sponge and mild
detergent in warm water. Dry thoroughly with a soft cloth.
5.
Replace the removable parts.
6.
Clean the condenser coils regularly. They are located behind
the base grille. Coils may need to be cleaned as often as
every other month. This may help save energy.
■
Remove the base grille. See “Base Grille.”
■
Use a vacuum cleaner with an extended attachment to
clean the condenser coils when they are dusty or dirty.
■
Replace the base grille.
7.
Plug in refrigerator or reconnect power.
A. Tabs
B. Screws
B
A
A
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
