12
Timer
The range hood can be set to turn Off automatically after
15 minutes.
1.
Press and hold the desired fan speed button for 2 seconds.
The fan will run on the chosen speed for 15 minutes, and the
fan speed button light will flash continuously.
After 15 minutes, the fan will turn Off automatically.
2.
Press the desired fan speed button again while the fan timer
is running to cancel the fan timer.
NOTE:
Changing the fan speed or turning Auto Sense On will
also cancel the 15-minute timer.
Light
The range hood has both task and ambient lighting.
To operate the lights:
1.
Touch LIGHT once to turn the LED task lights On.
2.
Touch LIGHT again to turn LED task lights Off. The ambient
lights will turn On.
3.
Touch LIGHT a third time to turn the ambient lights Off.
NOTE:
To turn both the task and ambient lights on at the same
time, touch and hold LIGHT for 2 seconds. Touch LIGHT again to
turn the task and ambient lights Off.
RANGE HOOD CARE
Cleaning
IMPORTANT:
Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
■
Liquid detergent soap and water, or all-purpose cleanser
■
Wipe with damp soft cloth or nonabrasive sponge, and then
rinse with clean water and wipe dry.
Metal Grease Filter
1.
Open the stainless steel panel. Grasp panel at the front
corners and pull down to disengage the 2 catch pins from the
spring catches. The panel is attached at the rear and will
rotate down.
2.
Remove each filter by pulling the spring release handle and
then pulling down the filter.
3.
Wash metal filters as needed in dishwasher or hot detergent
solution.
4.
Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
5.
Push in spring release handle.
6.
Push up on metal filter and release handle to latch into place.
7.
Repeat steps 1 through 5 for the other filter.
8.
Close the stainless steel panel. Engage the (2) pins in the
spring catches to secure.
Non-Vented (Recirculating) Installation Filters
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
“Accessories” section for information on ordering.
To replace charcoal filter:
1.
Remove metal grease filter from range hood. See “Metal
Grease Filter” in this section.
2.
Bend spring clips away from metal grease filter.
3.
Place charcoal filter into top side of metal filter.
A. Metal filters
B. Stainless steel panel
C. Catch pins (2)
D. Spring catches (2)
C
D
A
B
A. Spring release handle
A
