8
2.
Position the 4 vertical supports (A) with notches at the bottom
and attach to the range hood using 16 - 4.2 x 8 mm screws.
3.
Attach the horizontal support (B) using 8 - 4.2 x 8 mm screws.
4.
Attach a second set of vertical supports (A) and set the
vertical height (B). See “Installation Dimensions” in the
“Location Requirements” section to help determine the
desired dimension for the vertical height (B). Secure with
16 - 4.2 x 8 mm T20
®
screws.
5.
Using 2 or more people, lift the range hood assembly and
attach it by snapping the vertical supports to the spring clips
in the upper horizontal support bracket that is mounted to the
ceiling.
NOTE:
The range hood assembly must be held in place while
installing the screws in the next step.
6.
Install 16 - 4.2 x 8 mm screws and tighten to secure.
Connect Vent System
1.
Install vent system.
2.
Push duct over the exhaust outlet. Seal all connections with
vent clamps.
3.
Use caulk to seal all openings.
Non-Vented (Recirculating) Installation
1.
Attach the air deflector to the upper horizontal support using
4 mounting screws.
2.
Measure the length of 6" (15.2 cm) duct needed to connect
the transition to the deflector.
NOTE:
Vent should fit up inside the deflector 1" (2.5 cm)
minimum.
3.
Install vent between the transition and the deflector.
NOTE:
To make vent installation easier, temporarily remove
the deflector from the chimney support bracket and replace
after vent section is in place.
4.
Seal all connections with vent clamps.
Make Electrical Connection
1.
Disconnect power.
2.
Remove terminal box cover.
3.
Remove the knockout in the terminal box, and then install a
UL listed or CSA approved
¹⁄₂
" (12.7 mm) strain relief.
A. Vertical supports
B. Horizontal support
A. Vertical supports
B. Vertical height
A. Mounting screws
B
A
A
B
A
A
A
A. Deflector
B. Mounting screws
A. Knockout
B. Terminal box
C. Terminal box cover
B
B
A
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
A
C
B
