CONTROLS & FEATURES
3
CONTROLS: FILTER CHANGE INDICATOR (CARBON FILTERS)
Filter Change Reminder (Carbon, if fitted):
When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of
Carbon Filters to purify exhaust and fumes from cooking, then re-circulate the air within the home.
These Carbon Filters are required to be replaced after every 120 hours of use. The
Filter Change
Reminder
function in the microprocessor needs to be switched on. The microprocessor in the
controls when set, will elapse and count usage time and indicate by a flashing when carbon
filter replacement is needed.
Setting the Filter Change Reminder:
When Off, hold for approx. 5 seconds.
The display will change from
(exhaust mode) to , (purifying mode/
carbon filters used) this indicates that the
elapse timer function is switched on and
Carbon Filters are used.
Filter Replace Indicator:
When the display starts flashing, the
Carbon Filters require replacement.
Re-setting Function:
Once filters are replaced, with hood off,
press and hold , the display will appear;
hold for approximately 5 seconds until
on display disappears . The Filter
Change Reminder is now re-set and a new
120 hours elapse cycle is initiated.
hold 5 secs.
hold 5 secs.
display from <--> to <C>
display from <C> to < >
display <C> flashes
Set Mode
Change Filters
To Reset
Summary of Contents for JXT5830
Page 2: ......
Page 3: ...H S S...
