GENERAL INFORMATION (CONT.)
1-12
n
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
Water Dispenser
To Dispense Water:
1. Press a sturdy glass against the water dispenser pad.
NOTE:
n
While dispensing water and for 3 seconds after
dispensing has stopped, the digital display will show
how many ounces of water have been dispensed.
n
Water will only dispense when left door is closed and
will stop dispensing when door is opened.
n
It is NOT possible to dispense both water and ice at
the same time. The paddle that is pressed first will be
the one that dispenses.
2. Remove the glass to stop dispensing.
NOTE:
Water may have an off-flavor if you do not use the
dispenser periodically. Dispense enough water every week to
maintain a fresh supply.
Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser pad is pressed. The dispensing system will not
operate when the freezer door is open.
Your ice maker can produce both crushed and cubed ice. The
display screen reads "CRUSHED" or "CUBED," indicating which
type is selected. To change the setting, press the ICE button
before dispensing ice.
For crushed ice, cubes are crushed before being dispensed. This
may cause a slight delay when dispensing crushed ice. Noise from
the ice crusher is normal, and pieces of ice may vary in size.
When changing from crushed to cubed, a few ounces of crushed
ice will be dispensed along with the first cubes.
To Dispense Ice:
1.
Press the button to select the desired type of ice.
2. Press a sturdy glass against the ice dispenser pad. Hold the
glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT:
You do not need to apply a lot of pressure to
the pad in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE:
Ice may continue to dispense for up to 10 seconds
after removing the glass from the pad. The dispenser may
continue to make noise for a few seconds after dispensing.
Dispenser Tray (on some models)
Some models have a tray at the bottom of the dispenser area.
The tray is designed to catch small spills and is removable for
easy emptying and cleaning.
NOTE:
There is no drain in the tray.
Setting Liters and Ounces
Hold [Max Freezer] + [Crisper] button for 3 seconds to switch
between L and OZ.
When activated, the corresponding point LED is lit at FULL
brightness. The LED will turn off after 10 seconds if it’s not in the
mode associated to the water amount mode.
The L/OZ only turns on when there is an interaction associated to
water amount (e.g. measured fill, calibration.)
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
WARNING
