COMPONENT ACCESS (CONT.)
4-16
n
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
Removing the Receiver Cover and
Circuit Board (Dispensing Units Only)
1. Locate the Receiver on the inner wall and remove three (3)
phillips head screws to remove cover and board.
2.
After disconnecting wire harness, remove two (2) phillips
head screws to remove the emitter circuit board.
FC Door (Dispensing Units Only)
Removing the Front Decorative Cover
1. Complete the steps
from section Removing the Front
Decorative Cover.
Removing the User Interface
1. Release two (2) locking tabs securing the user interface or UI
to the dispenser housing.
2. Drop down the UI.
3.
Remove wire harness connections to remove UI.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.