Jenn-Air Luxury Series Service Manual Download

Page: 54 / 78

ARTE

TORAGE

RAWER

TO REMOVE:

• Pull the drawer out until it stops.
• Tilt the drawer up and pull it out.

TO REINSTALL:

• Slide the empty drawer bracket back on

the track until the bracket tab slips
under the track “catch.”

• Tilt the drawer front up, slide the

drawer back into place (until the bar
rests in the slot at the bottom front of
the drawer).

• Close the drawer.

TO REMOVE THE STORAGE
DRAWER FRAME:

• Remove drawer.
• Lift up the rear of the frame slightly.
• Pull the frame straight out.

TO MOVE THE DRAWER FRAME
TO ANOTHER POSITION:

• Insert the rear hooks into the desired

openings.

• Let the frame settle into place.
• Be sure the frame is level and securely

locked at the rear before putting the
drawer back in.

• Push up the tabs under the outside

edges of the shelf behind the front
bracket and continue pulling the shelf
out, until it clears frame.

TO REINSTALL:

• Align the shelf into the guides on the

frame.

• Push the shelf all the way back. (It is not

necessary to push up the tabs for rein-
stallation).

In ordinary use, the Elevator™ shelf frame
assembly does NOT require removal.

In the unlikely event that the assembly
needs to be removed, it is important to
follow the correct removal procedure.

TO REMOVE THE FRAME
ASSEMBLY:

F R E S H F O O D C O M P A R T M E N T

HELVES

The Fresh Food Compartment is
equipped with Standard Adjustable
Shelves and/or Elevator™ Shelves (fea-
tures may vary by model).

Both shelf styles feature a spill retainer
edge.They also slide out for easier access
to items stored at the rear of the shelf.

To slide out, grasp the front of the shelf
and pull. Gently push in to return the shelf
back to its original position.

TANDARD

DJUSTABLE

HELVES

TO REMOVE OR ADJUST:

• Completely unload the shelf.

• Lift up the rear of the shelf slightly.

• Pull the shelf straight out.

TO LOCK SHELF INTO ANOTHER
POSITION:

• Tilt up the front edge of the shelf.

• Lift up the rear of the shelf.

• Insert the hooks into the desired frame

openings.

• Let the shelf settle into place.

• Be sure the shelf is level and securely

locked at the rear before reloading it.

LEVATOR

™ S

HELF

The Elevator™ shelf can be adjusted up
or down without being unloaded.

To adjust the height, pull out the knob on the
handle built into the shelf front. Turn the
handle clockwise to raise the shelf and coun-
terclockwise to lower the height of the shelf.

TO REMOVE SHELF FOR
OCCASIONAL CLEANING:

• Completely unload the shelf.
• Partially slide

the shelf out.

• Unload the shelf completely.
• Slide the shelf forward about two

inches (6 cm). Manually move the two
rear latches toward the shelf center.

• While supporting the entire shelf and

frame from underneath, lift slightly and
rotate the assembly approximately 30°
to allow the rear mechanism to clear
the rear rails.

The entire assembly can then be moved
forward and clear of the refrigerator com-
partment.

To reinstall, reverse the removal proce-
dure. Be sure the shelf is in a level posi-
tion. When the sliding shelf is pushed to
the rear, the rear latches will reposition to
their correct operating position.

NOTE:

To remove the entire compart-

ment assembly surrounding the Climate-
Zone™ drawers, refer to page 19.

• Hold on to the lower bar support.