25
Adjust Flame Height
Adjust Surface Burner Flame
Adjust the height of top burner flames. The cooktop “low” burner
flame should be a steady blue flame approximately 1/4" (6.3 mm)
high. Propane gas flames have a slightly yellow tip.
A.
Low flame
B.
High flame
To Adjust Standard Burner:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
If the “Low” Flame Needs to Be Adjusted:
1.
Light 1 burner and turn to lowest setting.
2.
Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small flatblade
screwdriver to turn the screw located in the center of the
control knob stem until the flame is the proper size. Turning
the screw clockwise will increase the flame size and
counterclockwise will decrease the flame size.
A.
Control knob stem
B.
Screwdriver
C.
Pliers
3.
Replace the control knob.
4.
Test the flame by turning the control from the low position to
the high position, checking the flame at each setting.
5.
Repeat the previous steps for each burner.
To Adjust Double Burner (on some models):
1.
Light burner and turn to lowest setting where both inner and
outer burners are lit.
2.
Remove the control knob.
3.
Insert a 1/8" (3 mm) flat-blade screwdriver into the adjustment
locations shown in the following illustration and engage the
slotted screw. Turn the screw until the flame is the proper size.
Turning the screw clockwise will increase the flame size and
counterclockwise will decrease the flame size.
A.
Control knob stem
B.
Screwdriver
C.
Pliers
4.
Replace the control knob.
5.
Test the flame by turning the control from the low position to
the high position, checking the flame at each setting.
Check Operation of Oven Bake Burner
Refer to the Quick Start Guide and online Control Guide for proper
operation of the oven controls.
Adjust Oven Bake Burner Flame (If Needed)
1.
Remove the storage drawer (see the “Remove/Replace
Drawer” section).
2.
Locate gas pressure regulator at rear of the drawer
compartment.
A.
Gas pressure regulator
IMPORTANT:
Do not remove the gas pressure regulator.
Summary of Contents for MGS8800PZ
Page 55: ...NOTES...
Page 56: ...NOTES...
