26
CARE AND MAINTENANCE
REMOVAL OF GAS APPLIANCE
Gas appliance connectors used to connect this appliance to the gas supply are not designed for
continuous movement. Once installed, DO NOT repeatedly move this gas appliance for cleaning or to
relocate. If this appliance has to be moved and/or removed for servicing, follow the procedure
described in the installation instructions. For information, contact Jenn-Air Customer Service at
1-800-688-1100.
To prevent the range from accidentally tipping, the range must be secured to the floor by sliding the
rear leg into the anti-tip bracket.
WHEN CLEANING THE RANGE OR COOKTOP:
Be careful cleaning any part of this appliance while hot.
All parts of the appliance can be cleaned with hot soapy water, rinsed, dried and buffed to a shine with
a soft, heavy pile cloth. Always try this first, as it is the mildest cleaning procedure.
1) Use the mildest cleaning procedure first. Some brands of cleaners of the same type are harsher
than others, read their directions. A scent or a propellant can make a difference in the product,
read the ingredients. Try on a small area first.
2) To avoid marring the surface always rub metal finishes in the direction of the polish lines. The
cleaner will be more effective when used in the direction of the polish lines.
3) Use only clean sponges, soft cloths, paper towels, plastic non-metal or steel wool soap pads for
cleaning or scouring (use only soap pads with soap still in them, an empty pad can scratch), as
recommended in this section.
4) Be sure to rinse all parts thoroughly and to wipe dry to avoid water marks.
BRAND NAMES
In this section on cleaning, the use of name brands is intended only to indicate a type of cleaner.
This does not constitute an endorsement. The omission of any name brand cleaner does not imply
its adequacy or inadequacy. Many products are regional in distribution and can be found in local
markets and department stores.
COOKTOP
Turn off all the burners and allow the grates to cool, before starting to clean the cooktop. If you wipe
off any part of the cooktop while it is hot do so carefully as using a wet sponge or cloth can result in
steam burns.
BURNER GRATES
When lifting the grates be careful as they are heavy. Place them on a protected surface, so they won’t
scratch the surface they are laid on. The burner grates are matte porcelain enamel over cast iron.When
cool they may be placed in the dishwasher, or wiped clean while on the cooktop using hot soapy water,
then rinsed and wiped dry. The burner grates will not rust as they are matte porcelain enamel on both
sides for durability.
The occasional use of mild abrasive cleansers such as Bon-Ami®, Soft Scrub® or a soap-filled steel wool
pad is okay. Abrasive cleansers, used vigorously or too often, can eventually harm the enamel. Apply
with a damp sponge, rinse thoroughly and dry. The porcelain may pop off the edge of the grates due
to rapid temperature change when the burners are turned on. Do not be concerned as this does not
result in the deterioration of the grates. The cast iron soon darkens to blend with the porcelain enamel.
Be careful when wiping an area where the porcelain has popped off, as the edges may be sharp.
Summary of Contents for PRD3030
Page 71: ...NOTES 35 ...
Page 107: ...NOTAS 35 ...
Page 108: ...NOTAS 36 ...
Page 109: ...NOTAS 37 ...