11
■
To lower, turn the leveling screw counterclockwise.
3. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same
amount.
4. Replace the base grille.
REFRIGERATOR USE
Opening and Closing Doors
(French door models)
There are two refrigerator compartment doors. The doors can be
opened and closed either separately or together.
There is a vertically-hinged seal on the left refrigerator door.
■
When the left side door is opened, the hinged seal
automatically folds inward so that it is out of the way.
■
When both doors are closed, the hinged seal automatically
forms a seal between the two doors.
Using the Controls
Your model may have either Electronic, Dial or Digital Controls.
IMPORTANT:
■
Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has cooled
completely, your food may spoil.
NOTE: Adjusting the Refrigerator and Freezer Controls to a
higher (colder) than recommended setting will not cool the
compartments any faster.
■
The recommended settings should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream is
firm.
■
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
Electronic and Dial Controls
For your convenience, the temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
Style 1
Recommended Setting “4”
Style 2
Recommended Setting “4”
To Turn Off/On:
Style 1 Press the freezer Down Arrow control until a dash (-)
appears in both the refrigerator and freezer displays. Neither
compartment will cool.
Style 2 Turn the freezer control to the word OFF. Neither
compartment will cool when the freezer is set to OFF.
Energy Saver Option (on some models)
The energy saver option turns off the heater which helps to reduce
moisture on the door hinge seal. The refrigerator uses more
energy when Energy Saver is off.
■
Press the control to ON to save energy when the environment
is less humid.
■
Press the control to OFF when the environment is warm and
more humid, or if you notice moisture on the door hinge seal.
Adjusting Controls
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart below as
a guide.
To adjust the temperature, (Style 1) press the Up Arrow or Down
Arrow control, (Style 2) turn the dial to the desired setting. Except
when starting the refrigerator, do not adjust either control more
than one setting at a time. Wait 24 hours between adjustments for
the temperature to stabilize.
A. Leveling screw
A. Hinged seal
A
A
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR too warm
REFRIGERATOR Control
one setting higher
FREEZER too warm/too little ice
FREEZER Control one
setting higher
REFRIGERATOR too cold
REFRIGERATOR Control
one setting lower
FREEZER too cold
FREEZER Control one
setting lower
