19
3.
Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4.
Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number and
have a groove in the hex area. Replace the Natural gas orifice
spud with the correct Propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Fully insert choke into bottom of x-large burner base. Choke
should snap into place.
NOTE:
Use only for spreader bases marked “XL.”
Propane Gas Orifice Spud Chart for Surface Burner
Placement
Burner Rating
/ Type
Size (mm)
ID Number
LF
14,200 BTU
1.08
108AM
LF (ST)
15,000 BTU
0.84
084AM
LR
5,000 BTU
0.64
064AM
RF
14,200 BTU
1.08
108AM
RR
8,000 BTU
0.84
084AM
CTR
8,000 BTU
0.84
084AM
*Not in all kits/models.
NOTE:
Refer to the Model Number and Serial Number Plate
located on the oven frame behind the top right side of the oven
door for proper sizing of spuds for each burner location.
5.
Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
6.
Replace the burner base.
7.
Replace burner cap.
8.
Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner (Natural Gas to
Propane Gas)
1.
Remove the oven racks and the oven door. See the “Oven
Door” section.
2.
Remove two screws and washers at the rear of the oven
bottom.
3.
Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A. Screws
B. Oven bottom
4.
Remove two screws from the bake burner.
5.
Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the oven
orifice and set the bake burner aside. Do not disconnect the
wire.
A. Bake burner
B. Screws
A. Oven orifice
6.
Apply masking tape to the end of a 3/8" (9.5 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning the Natural gas bake burner orifice spud
counterclockwise to remove. The spud will be stamped with a
“47.”
