22
3.
Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4.
Gas orifice spuds are stamped with a number on the side.
Replace the Propane gas orifice spud with the correct Natural
gas orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
5.
Remove choke from x-large burner base.
Natural Gas Orifice Spud Chart
Burner Rating
Size (mm)
ID Number
19,000 BTU
1.96
196AM
17,000 BTU (ST)
1.84
184AM
17,000 BTU
1.96
196AM
15,000 BTU
1.75
175AM
9,200 BTU
1.35
135AM
8,000 BTU
1.25
125AM
5,000 BTU
1.00
100AM
1,450 BTU
0.53
053AM
NOTE:
Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door for
proper sizing of spuds for each burner location.
6.
Place Propane gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Propane gas orifice spuds in case of
reinstallation with Propane gas.
7.
Replace the burner base.
8.
Replace burner cap.
9.
Repeat steps 1 through 7 for the remaining burners.
s
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1.
Remove the oven racks and the oven door. See the “Oven
Door” section.
2.
Remove two screws and washers at the rear of the oven
bottom.
3.
Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A. Screws
B. Oven bottom
4.
Remove two screws from the bake burner.
5.
Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the oven
orifice, and set the bake burner aside. Do not disconnect the
wire.
A. Bake burner
B. Screws
A. Oven orifice
6.
Apply masking tape to the end of a 3/8" (9.5 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning the propane gas bake burner orifice spud
counterclockwise to remove. The spud will be stamped with a
“56.”
