21
S
TORAGE
D
RAWER
(
SELECT
MODELS
)
• Do not store plastic, paper products,
food or flammable materials in this
drawer. The drawer may become too
warm for these items when the oven is
in use.
The storage drawer can be removed to
allow you to clean under the range.
TO REMOVE:
1.
Empty drawer and pull out to the first
stop position.
2.
Lift up the front of the drawer.
3.
Pull out to the second stop position.
4.
Grasp sides and lift drawer up and out.
TO REPLACE:
1.
Fit the ends of the drawer glides into the
rails in the range.
2.
Lift up the front of the drawer and gently
push in to the first stop position.
3.
Lift drawer up again and push until drawer
is closed.
CAUTION:
R
EMOVAL
OF
G
AS
A
PPLIANCE
Gas appliance connectors used to connect
this appliance to the gas supply are not
designed for continuous movement. Once
installed,
DO NOT
repeatedly move this
gas appliance for cleaning or to relocate. If
this appliance has to be moved and/or
removed for servicing, follow the proce-
dure described in the installation instruc-
tions. For information, contact Jenn-Air
Customer Service at 1-800-688-1100.
To prevent range from accidentally tipping,
range must be secured to the floor by
sliding rear leveling leg into the anti-tip
bracket.
W
ARMING
D
RAWER
(
SELECT
MODELS
)
CAUTION:
• Do not store plastic, paper products or
flammable materials in this drawer. The
drawer may become too warm for these
items when the oven is in use or the
warming drawer is preheated.
• To avoid contact with the warming
drawer heating element, pull drawer all
the way out to add or remove food.
• Never use oven cleaners to clean the
warming drawer.
TO REMOVE WARMING DRAWER:
1.
Empty drawer and pull out to its full
open position.
2.
Locate the black triangle lever on each
side of the drawer.
3.
Press the lever down on the right side
and lift the lever up on the left side at the
same time. Then pull drawer out an-
other inch.
4.
Carefully pull the drawer all the way out
holding on to the sides, not the drawer
front.
TO REPLACE WARMING DRAWER:
1.
Pull the bearing glides to the front of the
chassis glide. (See picture below.)
2.
Align the glide on each side of the
drawer with the glide slots on the range.
3.
Push the drawer into the range until
levers “click” (approximately 2”). Pull
the drawer open again to seat bearing
glides into position. If you do not hear
the levers “click” or the bearing glides
do not feel seated, remove the drawer
and repeat steps 1 through 3. This will
minimize possible damage to the bear-
ing glides.
M
AINTENANCE
,
CONT
.
