Step # 11
Replacing Cup motor
After removing the single cup
assembly, remove the four philip
headed screws holding the motor
plate to the assembly. Be careful
when unbolting the motor plate,
there are still three screw to loosen
before the motor cam will be
released and motor plate can be
removed.
Step # 12
Replacing Cup motor
The three screws needed to be
loosened are shown to the right.
Once they are loosened the motor
shaft will slide out of the motor cam
and then can be removed with the
motor plate from the assembly.
DIAGNOSE MOTOR / SENSOR FAULT AND REPLACEMENT PROCEDURE
Step # 10
Replacing Cup motor or Cup sensor
After removing the top, place the
main cup assembly on it's side and
remove the four philip head screws
that coorespond to the cup location
that needs to be removed. Make sure
to support the single cup assembly
while removing it from the main
assembly. If replacing the cup sensor
the screws will be easily accessable at
this point.
Jennison Entertainment Technologies
Power Pong Service Manual
Page 42