Replacing Cup motor
Once the main cup assembly is
reinstalled into the game and all
connections are made, including the
main cup assembly ground strap, and
LED PCB board, power up the game
and make sure all is functioning
properly. To reinstall the pyramid cup
acrylic power down the game while
the cups arein the up position to add
in installation. Start in the lower right
corner working from that cup accross
and upwards.
Step # 12
Replacing Cup motor
Making sure all rubber cup lips fed
though the acrylic untill all six cups
are though. Note: sometimes it is
easyier to fed them though with your
hand under the acrylic as shown
here. Remember that the shorter of
the 2.5 mm hex headed screws goes
in the middle location of the acrylic.
DIAGNOSE MOTOR / SENSOR FAULT AND REPLACEMENT PROCEDURE
Step # 13
Replacing Cup motor
Turn the motor assembly over and
remove the four philip headed screws
holding the motor to the motor plate.
Replace motor and reassemble in the
reverse order till you get to the
pyramid cup acrylic. Making sure not
to overtighen any or the hardware.
Step # 11
Jennison Entertainment Technologies
Power Pong Service Manual
Page 43
