34
10.1
Start WebMotion
®
Start your web browser with the IP address number of
your XENAX® and add “
/xenax.html
”
as a suffix.
IP address is provided on the back side of the XENAX®.
Example:
http://192.168.2.xxx/xenax.html
XENAX® is being started with an automatic system self-
check including type designation and version information
on firmware and hardware. Moreover, WebMotion®
identifies the connected linear motor or rotary motor and
uploads the current XENAX® settings (parameters,
programs) in to the WebMotion®.
Interruption of TCP/IP Connection
If the XENAX® logic supply is interrupted or if the Ethernet
cable is disconnected, the TCP/IP interruption will be
detected by WebMotion® and signaled with “offline”. After
removing the cause of the offline-mode, the TCP/IP
connection has to be reloaded by updating the current
web browser window.
If it is still blocked, it is recommended to first exit and then
restarts the web browser.
10.1.1
Error
„Upload XENAX Settings®“
The settings in Kaspersky Internet Security might be
responsible
if the error code „Error Upload XENAX
Settings“ occurs with the automatic self
-check of
WebMotion®.
If you are using Kaspersky or similar internet security
software, the security for Instant Messenger Services has
to be deactivated.
(Refer
example in
Kaspersky
Pure 3.0)
