9
15. Do not operate near f ammable or combustible materials.
This product is not intended for use in locations where f re or explosion hazards may
exist due to the presence of f ammable vapors, liquids or gases, or combustible dusts
or f bers.
Heat generated by the compression cycle and/or drive system is released into
the atmosphere and can cause materials in close proximity to reach their f ash
temperatures and ignite or explode.
Always operate the compressor in a well ventilated area.
Always store f ammable or combustible materials in a secure location away from all
open f ames, sparks, and heat sources.
16. Do not remove any air line or receiver connections before relieving air
pressure in the entire air system and receiver tank(s).
This machine is capable of producing extremely high pressures and/or
temperatures. The pressurized spray can cut exposed f esh like a knife. The
spray can also cause severe irritation, cuts and/or burns. It can inject air and/or
harmful particles and chemicals into the skin and other soft tissues, and this can
result in serious injury or death. To prevent this from happening, always relieve the
air pressure in the entire system and in the receiver tanks before removing any air
lines or receiver connections.
17. Do not operate at pressures, temperatures and rotational speeds in excess of
the manufacturers recommendations.
With safety in mind, the unit was designed and is tested to withstand specif c operating pressures,
temperatures, and volumes. The different components of the machine are matched to produce the
factory set operating pressure and volume. Any modif cation of these settings can cause damage to
the compressor and/or maintenance and operating personnel
Never make adjustments and/or parts substitutions to alter the factory set operating pressures,
temperatures, and volumes.
18. Do not spray f ammable or toxic liquids in conf ned areas. Areas must be well
ventilated. Follow all manufacturers supplied instructions of the material to be
sprayed and the warnings associated with those products.
Never spray f ammable liquids in conf ned areas. The f ammable vapors may
accumulate and then ignite causing an explosion. Always spray f ammable liquids in a
well ventilated area free from combustible materials, gasoline, or solvent vapors.
Never spray toxic liquids or chemicals in conf ned areas. The toxic vapors may
accumulate and overcome the operator. Injury or death may result.
Read and follow all the safety instructions provided on the product label and Material
Summary of Contents for Reciprocating Air Compressors
