5
Knives and counter – knife
Observe to re – tighten screws by using the safety discs. The machine is equipped
with a simply exchangeable and reversible counter – knife in tapered execution. It
has two sharp edges. Avoid from dirt when disassemble – mounting the counter –
knife, clean the surfaces from dirt and chips.
Power requirements
Depending from material to be chopped at minimum 9 HP (6,6 KW)
Chipping length
Only hydraulic valve = approx. 20mm
Hydraulic capacity regulator = 5 up to 20mm (larger pieces on request).
Attention:
Use only spare parts origin JENSEN. No warranty in case of using other
products. In case of spare part order always mention the number of this machine.
Technical Specifications for woodchippers
Maximum wood diameter: (depending on wood and engine)
A141 = 26cm
A141XL = 30cm
A041 = 30cm
A231 = 24cm
A240 = 24cm
A328 = 20cm
A340 = 20cm
A425 = 18cm
A430 = 18cm
A521 = 13cm
A521XL = 15cm
A528 = 15cm
A530 = 15cm
On heavy feed please watch the rpm of the chipper – disk!
In case the rpm drops, you should disengage the hydraulic feed rollers and do not
engage again before the machine is back to the full rpm.
Necessary power:
with 2 knife and mixed bushes you need about 6.6 KW.
The power you really need depends on the sorting and the kind of the wood, the
speed of feed and the number of knifes in your machine.
Chipping – length:
Using hydraulic feed rollers you can adjust the length between 0
and 5cm with the regulator (special order).
Caution!
Knife – screws and all screw on the transportation – axle should be
controlled regularly and tightened following the table:
Forces for bolts and nuts class 8.8:
Size
Nm
kpm
M20
410
41
M16
210
21
M12
86
8,6
M10
49
4.9
M8
25
2,5
M6
10
1
¾
“
340
34