GB - 8
TO SET/RECALL RADIO STATION PRESETS
1. Press the button to turn the unit ON.
2. Tap the
button repeatedly to select AM or FM band. The corresponding indicator
will be lights up.
3. Use the
or
button to select the desired radio station.
4. Tap the MEMORY
button; the next available preset memory number will flash in the
LED display. (Note: “P01” will blink in the display if you are programming presets for
the first time.)
5. Press the
or
button to change to the desired preset number P01 thru P20.
6. Repeat steps #3 thru #5 to preset up to 20 stations.
7. To recall one of the preset stations already programmed, tap the button repeatedly
until you reach the desired preset number/radio station.
AUTOMATIC SET FOR RADIO STATION PRESETS
Press and hold the AUTO SCAN button for few seconds, the unit will start to search
radio stations and automatically save the first 20 stronger signal FM stations in FM mode
or AM stations in AM mode.
Note:
1.) Automatic preset will overwrite preset stations by overwriting and storing the newly
detected radio frequencies in their places.
2.) If some automatic presets not meet your expectation, then you will need to manually
set them afterwards.
SLEEP TIMER OPERATIONS
The sleep timer allows you to turn the unit off after a designated time is reached.
1. To activate the sleep timer, turn the unit on and either tune to the desired radio station
or listening to music via AUX IN.
2. Tap the SLEEP
button and the sleep time indicator appears on the display.
3. Repeatedly tap the
button to select a sleep timer of 5, 10, 15, 30, 60, 90 or 120
minutes. Wait 5 seconds after your selection for the unit to confirm the selection, the
unit will play for the selected length of time then automatically turn off.
4. To cancel the sleep timer, repeatedly tap the
buttons until timer shows “OFF”, sleep
indicator goes off.
5. To turn the unit off before the selected length of time, press and hold the button at any time.
Notes:
1.) To check the remaining sleep time, tap the
button once.
2.) If you are falling asleep to music from an external device connected to the AUX input, the
sleep timer will shut off the power to this system but it will not turn off the external device.
NAP FUNCTION
This function wakes you up after a short period of time. Only the beeping can be selected.
1. In standby mode, tap the NAP button repeatedly to select 120-90-60-30-15-10 or
5 minutes for your nap, wait 5 seconds for the unit to confirm your selection. The
indicator lights up.
2. To stop the NAP alarm when it sounds, press the or button.
3. To cancel NAP alarm before it sounding, tap the button repeatedly until display
shows OFF and wait for 5 seconds to confirm.
CR-3179 IB JENS 001- GB.indd 9
2013-6-10 15:01:47
